If you are planning to study Mechatronics and System Engineering at Abia State University located in Abia State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. ABSU was founded in 1981 and became a state university in 1992 to expand access to higher education in southeastern Nigeria. This page explains everything you need to know to increase your chances of gaining admission into ABSU.
Does Abia State University (ABSU) offer Mechatronics and System Engineering?
Wondering if ABSU offers Mechatronics and System Engineering in 2026? Since Abia State University can make changes to its Faculty of Engineering / Technology courses, we cannot confirm this with certainty. Check our updated ABSU Faculty of Engineering / Technology course list for the most recent information.
After Confirming Mechatronics and System Engineering at ABSU, Check the Admission Requirements
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechatronics and System Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
ABSU Mechatronics and System Engineering Suggested Cut-Off Mark if Offered
The general UTME cut-off mark is 180, but due to the variation of Mechatronics and System Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABSU Science Courses with their Requirements
1. Biochemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
2. Surveying and Geoinformatics
To study this course, the minimum requirement for applicants seeking admission to the Surveying and Geoinformatics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
3. Computer Science (CS)
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
4. Botany
To study this course, candidates seeking admission into the Botany department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Mathematics
To study this course, the minimum requirement for applicants seeking admission to the Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
6. Zoology
To study this course, candidates seeking admission into the Zoology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subject.
7. Geography
To study this course, candidates seeking admission into the Geography department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other two (2) Science subjects.
Nigerian Tertiary Institutions Offering Mechatronics and System Engineering Course