If you are planning to study Aeronautic and Astronautic Engineering at Abubakar Tafawa Balewa University located in Bauchi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ATBU.
Does Abubakar Tafawa Balewa University (ATBU) offer Aeronautic and Astronautic Engineering?
No, Abubakar Tafawa Balewa University does not offer Aeronautic and Astronautic Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Abubakar Tafawa Balewa University (ATBU) below to check if the Aeronautic and Astronautic Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Aeronautic and Astronautic Engineering When Accredited in Abubakar Tafawa Balewa University (ATBU)
O’Level Requirements
To study this course, candidates seeking admission into the Aeronautic and Astronautic Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
ATBU Cut-Off Mark for Aeronautic and Astronautic Engineering
The general UTME cut-off mark is 180, but due to the variation of Aeronautic and Astronautic Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ATBU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ATBU Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Geophysics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Geophysics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Education and Computer Science
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Computer Science department.
three (3) other relevant Science subjects.
Computer and Communication Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Computer and Communication Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Computer Science (CS)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
Chemistry
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Electrical / Electronics Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
Nigerian Tertiary Institutions Offering Aeronautic and Astronautic Engineering Course