If you are planning to study Electronics and Computer Technology at Abubakar Tafawa Balewa University located in Bauchi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. ATBU was established in 1980 as a Federal University of Technology and later renamed to promote science and engineering education in Nigeria. This page explains everything you need to know to increase your chances of gaining admission into ATBU.
Does Abubakar Tafawa Balewa University (ATBU) offer Electronics and Computer Technology?
No, Abubakar Tafawa Balewa University does not offer Electronics and Computer Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Abubakar Tafawa Balewa University (ATBU) below to check if the Electronics and Computer Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electronics and Computer Technology When Accredited in Abubakar Tafawa Balewa University (ATBU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electronics and Computer Technology department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
ATBU Cut-Off Mark for Electronics and Computer Technology
The general UTME cut-off mark is 180, but due to the variation of Electronics and Computer Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ATBU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ATBU Science Courses with their Requirements
1. Mechanical / Production Engineering
To study this course, candidates seeking admission into the Mechanical / Production Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
2. Medicine and Surgery
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Medicine and Surgery department.
3. Education and Computer Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Computer Science department.
three (3) other relevant Science subjects.
4. Zoology
To study this course, candidates aspiring to gain admission into Zoology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subject.
5. Architecture
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
6. Building Technology Education
To study this course, candidates aspiring to gain admission into Building Technology Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
7. Geophysics
To study this course, the minimum requirement for applicants seeking admission to the Geophysics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Nigerian Tertiary Institutions Offering Electronics and Computer Technology Course