If you are planning to study Wood Production Engineering at Abubakar Tafawa Balewa University located in Bauchi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. ATBU was established in 1980 as a Federal University of Technology and later renamed to promote science and engineering education in Nigeria. This page explains everything you need to know to increase your chances of gaining admission into ATBU.
Does Abubakar Tafawa Balewa University (ATBU) offer Wood Production Engineering?
No, Abubakar Tafawa Balewa University does not offer Wood Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Abubakar Tafawa Balewa University (ATBU) below to check if the Wood Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Wood Production Engineering When Accredited in Abubakar Tafawa Balewa University (ATBU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Wood Production Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
ATBU Cut-Off Mark for Wood Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Wood Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ATBU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ATBU Science Courses with their Requirements
1. Petroleum Engineering
To study this course, candidates seeking admission into the Petroleum Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Computer and Communication Engineering
To study this course, candidates seeking admission into the Computer and Communication Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
3. Crop Production
To study this course, the minimum requirement for applicants seeking admission to the Crop Production department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science,
one Science/Social Science subject and
at least ‘O’ Level pass in Physics.
4. Chemical Engineering
To study this course, candidates aspiring to gain admission into Chemical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
5. Agriculture
To study this course, the minimum requirement for applicants seeking admission to the Agriculture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science,
Mathematics / Physics, and
6. Medicine and Surgery
To study this course, the minimum requirement for applicants seeking admission to the Medicine and Surgery department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
7. Education and Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Science department.
two (2) other Science subjects and
any other relevant subjectes.
Nigerian Tertiary Institutions Offering Wood Production Engineering Course