If you are planning to study Prosthesis and Orthopaedic Technology at Adekunle Ajasin University located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into AAUA.
Does Adekunle Ajasin University (AAUA) offer Prosthesis and Orthopaedic Technology?
No, Adekunle Ajasin University does not offer Prosthesis and Orthopaedic Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Adekunle Ajasin University (AAUA) below to check if the Prosthesis and Orthopaedic Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Prosthesis and Orthopaedic Technology When Accredited in Adekunle Ajasin University (AAUA)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Prosthesis and Orthopaedic Technology department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
AAUA Cut-Off Mark for Prosthesis and Orthopaedic Technology
The general UTME cut-off mark is 180, but due to the variation of Prosthesis and Orthopaedic Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AAUA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AAUA Science Courses with their Requirements
1. Microbiology
To study this course, candidates aspiring to gain admission into Microbiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
2. Geology
To study this course, candidates aspiring to gain admission into Geology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
3. Physics With Electronics
To study this course, the minimum requirement for applicants seeking admission to the Physics With Electronics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject from Further Mathematics and Biology / Agricultural Science.
4. Education and Chemistry
To study this course, candidates seeking admission into the Education and Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology and Agricultural Science.
5. Mathematics
To study this course, candidates aspiring to gain admission into Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
6. Technical Education
To study this course, the minimum requirement for applicants seeking admission to the Technical Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any three (3) relevant subjects.
7. Industrial Chemistry
To study this course, candidates seeking admission into the Industrial Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science.
Nigerian Tertiary Institutions Offering Prosthesis and Orthopaedic Technology Course