If you are planning to study Construction Technology Education at Ahmadu Bello University located in Kaduna State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. ABU was established in 1962 as one of Nigeria’s premier federal universities to promote higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into ABU.
Does Ahmadu Bello University (ABU) offer Construction Technology Education?
No, Ahmadu Bello University does not offer Construction Technology Education under its Faculty of Built Environment. However, since our course list is updated regularly, you can visit the courses available at Ahmadu Bello University (ABU) below to check if the Construction Technology Education course under the Faculty of Built Environment has been updated.
Admission Requirements for Construction Technology Education When Accredited in Ahmadu Bello University (ABU)
O’Level Requirements
To study this course, candidates seeking admission into the Construction Technology Education department under Faculty of Built Environment, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
ABU Cut-Off Mark for Construction Technology Education
The general UTME cut-off mark is 180, but due to the variation of Construction Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABU Science Courses with their Requirements
1. Health Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Health Education department.
any two (2) other relevant subjects.
2. Education and Computer Science
To study this course, the minimum requirement for applicants seeking admission to the Education and Computer Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
three (3) other relevant Science subjects.
3. Building
To study this course, candidates aspiring to gain admission into Building department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
4. Education and Biology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Biology department.
5. Metallurgical Engineering
To study this course, candidates aspiring to gain admission into Metallurgical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one other Science subject.
6. Medical Laboratory Science
To study this course, candidates seeking admission into the Medical Laboratory Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
7. Chemical Engineering
To study this course, candidates seeking admission into the Chemical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Nigerian Tertiary Institutions Offering Construction Technology Education Course