If you are planning to study Electronics at Ahmadu Bello University located in Kaduna State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. ABU was established in 1962 as one of Nigeria’s premier federal universities to promote higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into ABU.
Does Ahmadu Bello University (ABU) offer Electronics?
No, Ahmadu Bello University does not offer Electronics under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ahmadu Bello University (ABU) below to check if the Electronics course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electronics When Accredited in Ahmadu Bello University (ABU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electronics department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology or Agricultural Science.
ABU Cut-Off Mark for Electronics
The general UTME cut-off mark is 180, but due to the variation of Electronics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABU Science Courses with their Requirements
1. Building
To study this course, candidates seeking admission into the Building department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
2. Biochemistry
To study this course, candidates aspiring to gain admission into Biochemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Water Resources and Environmental Engineering
To study this course, candidates seeking admission into the Water Resources and Environmental Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
4. Human Kinetics
To study this course, the minimum requirement for applicants seeking admission to the Human Kinetics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Health Science / Physical Education / Biology
Any other two (2) relevant subjects
5. Automotive Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Automotive Engineering department.
any other Science subject.
6. Physiology
To study this course, candidates seeking admission into the Physiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
7. Textile Science and Technology
To study this course, the minimum requirement for applicants seeking admission to the Textile Science and Technology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Nigerian Tertiary Institutions Offering Electronics Course