If you are planning to study Software Engineering and Digital Entrepreneurship at Ahmadu Bello University located in Kaduna State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. ABU was established in 1962 as one of Nigeria’s premier federal universities to promote higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into ABU.
Does Ahmadu Bello University (ABU) offer Software Engineering and Digital Entrepreneurship?
No, Ahmadu Bello University does not offer Software Engineering and Digital Entrepreneurship under its Faculty of Data and Decision Sciences. However, since our course list is updated regularly, you can visit the courses available at Ahmadu Bello University (ABU) below to check if the Software Engineering and Digital Entrepreneurship course under the Faculty of Data and Decision Sciences has been updated.
Admission Requirements for Software Engineering and Digital Entrepreneurship When Accredited in Ahmadu Bello University (ABU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Software Engineering and Digital Entrepreneurship department under Faculty of Data and Decision Sciences, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
three (3) other relevant subjects.
JAMB Subject Combination
two (2) other relevant subjects.
ABU Cut-Off Mark for Software Engineering and Digital Entrepreneurship
The general UTME cut-off mark is 180, but due to the variation of Software Engineering and Digital Entrepreneurship cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABU Science Courses with their Requirements
1. Surveying and Geoinformatics
To study this course, candidates seeking admission into the Surveying and Geoinformatics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
2. Dentistry and Dental Surgery
To study this course, candidates seeking admission into the Dentistry and Dental Surgery department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
3. Human Kinetics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Human Kinetics department.
Health Science / Physical Education / Biology
Any other two (2) relevant subjects
4. Water Resources and Environmental Engineering
To study this course, the minimum requirement for applicants seeking admission to the Water Resources and Environmental Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
5. Health Education
To study this course, candidates aspiring to gain admission into Health Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
6. Education and Physics
To study this course, the minimum requirement for applicants seeking admission to the Education and Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects or NTC / NBC.
7. Nursing (Science)
To study this course, candidates aspiring to gain admission into Nursing (Science) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Tertiary Institutions Offering Software Engineering and Digital Entrepreneurship Course