If you are planning to study Technical Education at Ahmadu Bello University located in Kaduna State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ABU.
Does Ahmadu Bello University (ABU) offer Technical Education?
No, Ahmadu Bello University does not offer Technical Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Ahmadu Bello University (ABU) below to check if the Technical Education course under the Faculty of Education has been updated.
Admission Requirements for Technical Education When Accredited in Ahmadu Bello University (ABU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Technical Education department under Faculty of Education.
any three (3) relevant subjects.
ABU Cut-Off Mark for Technical Education
The general UTME cut-off mark is 180, but due to the variation of Technical Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABU Science Courses with their Requirements
Pharmacy
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Pharmacy department.
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Chemical Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Chemical Engineering department.
any other Science subject.
Electrical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Electrical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Building
SSCE Requirements
To study this course, candidates seeking admission into the Building department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Education and Physics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Education and Physics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subjects or NTC / NBC.
Dentistry and Dental Surgery
SSCE Requirements
To study this course, candidates aspiring to gain admission into Dentistry and Dental Surgery department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Universities Offering Technical Education Course