If you are planning to study Technology and Vocational Education at Ahmadu Bello University located in Kaduna State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ABU.
Does Ahmadu Bello University (ABU) offer Technology and Vocational Education?
No, Ahmadu Bello University does not offer Technology and Vocational Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Ahmadu Bello University (ABU) below to check if the Technology and Vocational Education course under the Faculty of Education has been updated.
Admission Requirements for Technology and Vocational Education When Accredited in Ahmadu Bello University (ABU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Technology and Vocational Education department under Faculty of Education, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any three (3) other relevant subjects.
ABU Cut-Off Mark for Technology and Vocational Education
The general UTME cut-off mark is 180, but due to the variation of Technology and Vocational Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABU Science Courses with their Requirements
Education and Physics
SSCE Requirements
To study this course, candidates seeking admission into the Education and Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects or NTC / NBC.
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Glass Technology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Glass Technology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Spinning, Weaving, Surface Design and Printing, Bleaching, Dyeing and Finishing, Ceramics, Graphic Design, Graphic Printing, Decorative Painting,
Spray Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Building / Engineering Drawing, General Wood Work.
Anatomy
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Anatomy department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Zoology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Zoology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subject.
Surveying and Geoinformatics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
Biochemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
Nigerian Tertiary Institutions Offering Technology and Vocational Education Course