If you are planning to study Vocational and Technical Education at Ahmadu Bello University located in Kaduna State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ABU.
Does Ahmadu Bello University (ABU) offer Vocational and Technical Education?
No, Ahmadu Bello University does not offer Vocational and Technical Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Ahmadu Bello University (ABU) below to check if the Vocational and Technical Education course under the Faculty of Education has been updated.
Admission Requirements for Vocational and Technical Education When Accredited in Ahmadu Bello University (ABU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Vocational and Technical Education department under Faculty of Education.
any other relevant subject of specialization.
JAMB Subject Combination
any two (2) relevant subjects.
ABU Cut-Off Mark for Vocational and Technical Education
The general UTME cut-off mark is 180, but due to the variation of Vocational and Technical Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABU Science Courses with their Requirements
1. Physical and Health Education
To study this course, candidates aspiring to gain admission into Physical and Health Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology or its equivalent
and any two (2) other relevant subjects.
2. Physiology
To study this course, candidates seeking admission into the Physiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
3. Agricultural Science and Education
To study this course, candidates aspiring to gain admission into Agricultural Science and Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology/Agricultural Science,
any other relevant subject.
4. Surveying and Geoinformatics
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
5. Urban and Regional Planning (URP)
To study this course, the minimum requirement for applicants seeking admission to the Urban and Regional Planning (URP) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Physics, Chemistry, Economics, Government, Biology, Art, History, IRK/CRK, Social Studies and Tech Drawing.
6. Fisheries and Aquaculture
To study this course, candidates seeking admission into the Fisheries and Aquaculture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology/Agricultural Science,
Physics/Geography/Economics.
7. Mechatronics Engineering
To study this course, the minimum requirement for applicants seeking admission to the Mechatronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Nigerian Universities Offering Vocational and Technical Education Course