If you are planning to study Industrial Education Technology at Alex Ekwueme Federal University Ndufu Alike-Ikwo located in Ebonyi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into AE-FUNAI.
Does Alex Ekwueme Federal University Ndufu Alike-Ikwo (AE-FUNAI) offer Industrial Education Technology?
No, Alex Ekwueme Federal University Ndufu Alike-Ikwo does not offer Industrial Education Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Alex Ekwueme Federal University Ndufu Alike-Ikwo (AE-FUNAI) below to check if the Industrial Education Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Education Technology When Accredited in Alex Ekwueme Federal University Ndufu Alike-Ikwo (AE-FUNAI)
O’Level Requirements
To study this course, candidates seeking admission into the Industrial Education Technology department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
three (3) other relevant subjects.
JAMB Subject Combination
one (1) other Science subject.
AE-FUNAI Cut-Off Mark for Industrial Education Technology
The general UTME cut-off mark is 180, but due to the variation of Industrial Education Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AE-FUNAI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AE-FUNAI Science Courses with their Requirements
1. Electrical / Electronics Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
2. Environmental Management and Toxicology
To study this course, candidates seeking admission into the Environmental Management and Toxicology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
3. Fisheries and Aquaculture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Fisheries and Aquaculture department.
Biology/Agricultural Science,
Physics/Geography/Economics.
4. Geology
To study this course, the minimum requirement for applicants seeking admission to the Geology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
5. Physiotherapy
To study this course, candidates seeking admission into the Physiotherapy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Quantity Surveying (QS)
To study this course, the minimum requirement for applicants seeking admission to the Quantity Surveying (QS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
7. Computer Science (CS)
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
Nigerian Tertiary Institutions Offering Industrial Education Technology Course