If you are planning to study Engineering Physics at Ambrose Alli University located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into AAU.
Does Ambrose Alli University (AAU) offer Engineering Physics?
No, Ambrose Alli University does not offer Engineering Physics under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ambrose Alli University (AAU) below to check if the Engineering Physics course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Engineering Physics When Accredited in Ambrose Alli University (AAU)
O’Level Requirements
To study this course, candidates seeking admission into the Engineering Physics department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any one (1) of Health Science, Statistics, Physics and Geography.
JAMB Subject Combination
either Physics or Mathematics.
AAU Cut-Off Mark for Engineering Physics
The general UTME cut-off mark is 180, but due to the variation of Engineering Physics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AAU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AAU Science Courses with their Requirements
1. Education and Physics
To study this course, candidates seeking admission into the Education and Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects or NTC / NBC.
2. Architecture
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
3. Health Education
To study this course, the minimum requirement for applicants seeking admission to the Health Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
4. Statistics
To study this course, candidates seeking admission into the Statistics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
5. Building
To study this course, candidates seeking admission into the Building department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
6. Technical Education
To study this course, candidates aspiring to gain admission into Technical Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any three (3) relevant subjects.
7. Physical and Health Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physical and Health Education department.
Biology or its equivalent
and any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Engineering Physics Course