If you are planning to study Forestry and Wood Technology at Ambrose Alli University located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. AAU was established in 1981 by the Bendel State Government (now Edo State) to promote higher education and academic excellence in Nigeria. It has developed into a full-fledged state university. This page explains everything you need to know to increase your chances of gaining admission into AAU.
Does Ambrose Alli University (AAU) offer Forestry and Wood Technology?
No, Ambrose Alli University does not offer Forestry and Wood Technology under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at Ambrose Alli University (AAU) below to check if the Forestry and Wood Technology course under the Faculty of Agriculture has been updated.
Admission Requirements for Forestry and Wood Technology When Accredited in Ambrose Alli University (AAU)
O’Level Requirements
To study this course, candidates seeking admission into the Forestry and Wood Technology department under Faculty of Agriculture, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science,
at least ‘O’ Level pass in Physics.
JAMB Subject Combination
Mathematics / Physics and
Biology / Agricultural Science.
AAU Cut-Off Mark for Forestry and Wood Technology
The general UTME cut-off mark is 180, but due to the variation of Forestry and Wood Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AAU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AAU Science Courses with their Requirements
1. Architecture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
2. Botany
To study this course, candidates aspiring to gain admission into Botany department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Medicine and Surgery
To study this course, the minimum requirement for applicants seeking admission to the Medicine and Surgery department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
4. Physics
To study this course, the minimum requirement for applicants seeking admission to the Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
5. Education and Biology
To study this course, candidates aspiring to gain admission into Education and Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
6. Nursing (Science)
To study this course, the minimum requirement for applicants seeking admission to the Nursing (Science) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
7. Physical and Health Education
To study this course, the minimum requirement for applicants seeking admission to the Physical and Health Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology or its equivalent
and any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Forestry and Wood Technology Course