If you are planning to study Metallurgical and Material Engineering at Ambrose Alli University located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into AAU.
Does Ambrose Alli University (AAU) offer Metallurgical and Material Engineering?
No, Ambrose Alli University does not offer Metallurgical and Material Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ambrose Alli University (AAU) below to check if the Metallurgical and Material Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical and Material Engineering When Accredited in Ambrose Alli University (AAU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Metallurgical and Material Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one other Science subject.
AAU Cut-Off Mark for Metallurgical and Material Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical and Material Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AAU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AAU Science Courses with their Requirements
1. Industrial Chemistry
To study this course, the minimum requirement for applicants seeking admission to the Industrial Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science.
2. Physiology
To study this course, candidates aspiring to gain admission into Physiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Physical and Health Education
To study this course, candidates seeking admission into the Physical and Health Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology or its equivalent
and any two (2) other relevant subjects.
4. Building
To study this course, candidates aspiring to gain admission into Building department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
5. Computer Science (CS)
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
6. Vocational and Technical Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Vocational and Technical Education department.
any other relevant subject of specialization.
7. Statistics
To study this course, the minimum requirement for applicants seeking admission to the Statistics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
Nigerian Universities Offering Metallurgical and Material Engineering Course