If you are planning to study Metallurgical Engineering at Ambrose Alli University located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into AAU.
Does Ambrose Alli University (AAU) offer Metallurgical Engineering?
No, Ambrose Alli University does not offer Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ambrose Alli University (AAU) below to check if the Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical Engineering When Accredited in Ambrose Alli University (AAU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Metallurgical Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one other Science subject.
AAU Cut-Off Mark for Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AAU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AAU Science Courses with their Requirements
Health Education
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Health Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
Civil Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Civil Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Anatomy
SSCE Requirements
To study this course, candidates seeking admission into the Anatomy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Building
SSCE Requirements
To study this course, candidates seeking admission into the Building department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Geophysics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Geophysics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Physical and Health Education
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physical and Health Education department.
Biology or its equivalent
and any two (2) other relevant subjects.
Nursing (Science)
SSCE Requirements
To study this course, candidates seeking admission into the Nursing (Science) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Metallurgical Engineering Course