If you are planning to study Polymer and Textile Engineering at Ambrose Alli University located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into AAU.
Does Ambrose Alli University (AAU) offer Polymer and Textile Engineering?
No, Ambrose Alli University does not offer Polymer and Textile Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ambrose Alli University (AAU) below to check if the Polymer and Textile Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Polymer and Textile Engineering When Accredited in Ambrose Alli University (AAU)
O’Level Requirements
To study this course, candidates seeking admission into the Polymer and Textile Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
AAU Cut-Off Mark for Polymer and Textile Engineering
The general UTME cut-off mark is 180, but due to the variation of Polymer and Textile Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AAU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AAU Science Courses with their Requirements
1. Education and Physics
To study this course, the minimum requirement for applicants seeking admission to the Education and Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects or NTC / NBC.
2. Mechanical Engineering
To study this course, candidates aspiring to gain admission into Mechanical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
3. Building
To study this course, candidates seeking admission into the Building department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
4. Electrical and Electronics Engineering (EEE)
To study this course, candidates seeking admission into the Electrical and Electronics Engineering (EEE) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
5. Statistics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Statistics department.
any other relevant subject.
6. Physical and Health Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physical and Health Education department.
Biology or its equivalent
and any two (2) other relevant subjects.
7. Civil Engineering
To study this course, candidates seeking admission into the Civil Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Polymer and Textile Engineering Course