If you are planning to study Industrial and Production Engineering at Bayero University, Kano located in Kano State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. BUK was established in 1975 as one of Nigeria’s first-generation federal universities to promote research, education, and national development in Northern Nigeria. This page explains everything you need to know to increase your chances of gaining admission into BUK.
Does Bayero University, Kano (BUK) offer Industrial and Production Engineering?
No, Bayero University, Kano does not offer Industrial and Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Bayero University, Kano (BUK) below to check if the Industrial and Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial and Production Engineering When Accredited in Bayero University, Kano (BUK)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Industrial and Production Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
BUK Cut-Off Mark for Industrial and Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Industrial and Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from BUK Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other BUK Science Courses with their Requirements
1. Computer Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Engineering department.
2. Agricultural Science and Education
To study this course, candidates aspiring to gain admission into Agricultural Science and Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology/Agricultural Science,
any other relevant subject.
3. Applied Biology
To study this course, the minimum requirement for applicants seeking admission to the Applied Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mathematics, Chemistry and
Health Science and Statistics.
4. Dentistry and Dental Surgery
To study this course, candidates seeking admission into the Dentistry and Dental Surgery department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Architecture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
6. Education and Biology
To study this course, the minimum requirement for applicants seeking admission to the Education and Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
7. Anatomy
To study this course, candidates seeking admission into the Anatomy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Universities Offering Industrial and Production Engineering Course