If you are planning to study Dentistry and Dental Surgery at Bells University of Technology located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Bells University.
Does Bells University of Technology (BUT) offer Dentistry and Dental Surgery?
No, Bells University of Technology does not offer Dentistry and Dental Surgery under its Faculty of Health and Medical Sciences. However, since our course list is updated regularly, you can visit the courses available at Bells University of Technology (BUT) below to check if the Dentistry and Dental Surgery course under the Faculty of Health and Medical Sciences has been updated.
Admission Requirements for Dentistry and Dental Surgery When Accredited in Bells University of Technology (BUT)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Dentistry and Dental Surgery department under Faculty of Health and Medical Sciences, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
JAMB Subject Combination
one (1) other Science subject.
Bells University Cut-Off Mark for Dentistry and Dental Surgery
The general UTME cut-off mark is 230, but due to the variation of Dentistry and Dental Surgery cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bells University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bells University Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Urban and Regional Planning (URP)
SSCE Requirements
To study this course, candidates seeking admission into the Urban and Regional Planning (URP) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Physics, Chemistry, Economics, Government, Biology, Art, History, IRK/CRK, Social Studies and Tech Drawing.
Communication Technology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Communication Technology department.
any two (2) other relevant subjects.
Telecommunication Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Telecommunication Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subjects.
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Mechatronics Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mechatronics Engineering department.
any other Science subject.
Biochemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
Nigerian Universities Offering Dentistry and Dental Surgery Course