If you are planning to study Industrial Production Engineering at Bells University of Technology located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Bells University was established in 2005 as a private university of technology in Ogun State to advance science, engineering, and technological education in Nigeria. This page explains everything you need to know to increase your chances of gaining admission into Bells University.
Does Bells University of Technology (BUT) offer Industrial Production Engineering?
No, Bells University of Technology does not offer Industrial Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Bells University of Technology (BUT) below to check if the Industrial Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Production Engineering When Accredited in Bells University of Technology (BUT)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Industrial Production Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Bells University Cut-Off Mark for Industrial Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Industrial Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bells University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bells University Science Courses with their Requirements
1. Biotechnology
To study this course, candidates seeking admission into the Biotechnology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Quantity Surveying (QS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Quantity Surveying (QS) department.
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
3. Nutrition and Dietetics
To study this course, candidates aspiring to gain admission into Nutrition and Dietetics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology/Agricultural Science.
4. Microbiology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Microbiology department.
5. Architecture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
6. Applied Mathematics with Statistics
To study this course, the minimum requirement for applicants seeking admission to the Applied Mathematics with Statistics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
7. Mechatronics Engineering
To study this course, candidates seeking admission into the Mechatronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Nigerian Tertiary Institutions Offering Industrial Production Engineering Course