If you are planning to study Metallurgical and Material Engineering at Bowen University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Bowen University was established in 2001 by the Nigerian Baptist Convention as a private faith-based university focused on academic excellence, discipline, and moral upbringing. This page explains everything you need to know to increase your chances of gaining admission into Bowen University.
Does Bowen University (BU) offer Metallurgical and Material Engineering?
Wondering if Bowen University offers Metallurgical and Material Engineering in 2026? Since Bowen University can make changes to its Faculty of Engineering / Technology courses, we cannot confirm this with certainty. Check our updated Bowen University Faculty of Engineering / Technology course list for the most recent information.
After Confirming Metallurgical and Material Engineering at Bowen University, Check the Admission Requirements
O’Level Requirements
To study this course, candidates seeking admission into the Metallurgical and Material Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one other Science subject.
Bowen University Metallurgical and Material Engineering Suggested Cut-Off Mark if Offered
The general UTME cut-off mark is 180, but due to the variation of Metallurgical and Material Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bowen University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bowen University Science Courses with their Requirements
1. Education and Biology
To study this course, candidates aspiring to gain admission into Education and Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
2. Surveying and Geoinformatics
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
3. Medicine and Surgery
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Medicine and Surgery department.
4. Education and Physics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Physics department.
two (2) other Science subjects or NTC / NBC.
5. Biochemistry
To study this course, candidates aspiring to gain admission into Biochemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
6. Nursing (Science)
To study this course, candidates aspiring to gain admission into Nursing (Science) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
7. Forestry and Environmental Management
To study this course, candidates aspiring to gain admission into Forestry and Environmental Management department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one of Physics, Economics, Further Mathematics and Statistics.
Nigerian Universities Offering Metallurgical and Material Engineering Course