If you are planning to study Metalwork Technology Education at Bowen University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Bowen University.
Does Bowen University (BU) offer Metalwork Technology Education?
No, Bowen University does not offer Metalwork Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Bowen University (BU) below to check if the Metalwork Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Metalwork Technology Education When Accredited in Bowen University (BU)
O’Level Requirements
To study this course, candidates seeking admission into the Metalwork Technology Education department under Faculty of Education, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science, Physics, or Chemistry
and two (2) from General Science / Integrated Science, Technical Drawing / Fine Art, Geography, Health Science Food and Nutrition, Physical and Health Education, Auto Technical, Building, Electrical Electronic, Metal Work and Wood Work.
Bowen University Cut-Off Mark for Metalwork Technology Education
The general UTME cut-off mark is 180, but due to the variation of Metalwork Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bowen University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bowen University Science Courses with their Requirements
1. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
2. Computer Science (CS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
3. Nutrition and Dietetics
To study this course, the minimum requirement for applicants seeking admission to the Nutrition and Dietetics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology/Agricultural Science.
4. Software Engineering
To study this course, the minimum requirement for applicants seeking admission to the Software Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
5. Mechatronics Engineering
To study this course, candidates aspiring to gain admission into Mechatronics Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
6. Public Health
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Public Health department.
7. Education and Chemistry
To study this course, the minimum requirement for applicants seeking admission to the Education and Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology and Agricultural Science.
Nigerian Tertiary Institutions Offering Metalwork Technology Education Course