If you are planning to study Polymer and Textile Engineering at Bowen University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Bowen University was established in 2001 by the Nigerian Baptist Convention as a private faith-based university focused on academic excellence, discipline, and moral upbringing. This page explains everything you need to know to increase your chances of gaining admission into Bowen University.
Does Bowen University (BU) offer Polymer and Textile Engineering?
Wondering if Bowen University offers Polymer and Textile Engineering in 2026? Because Bowen University's Faculty of Engineering / Technology course offerings may change, we cannot confirm the information as permanent. We recommend checking our updated course list for the latest Bowen University Faculty of Engineering / Technology courses.
After Confirming Polymer and Textile Engineering at Bowen University, Check the Admission Requirements
O’Level Requirements
To study this course, candidates seeking admission into the Polymer and Textile Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Bowen University Polymer and Textile Engineering Suggested Cut-Off Mark if Offered
The general UTME cut-off mark is 180, but due to the variation of Polymer and Textile Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bowen University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bowen University Science Courses with their Requirements
1. Nursing (Science)
To study this course, candidates seeking admission into the Nursing (Science) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Surveying and Geoinformatics
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
3. Nutrition and Dietetics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Nutrition and Dietetics department.
Biology/Agricultural Science.
4. Software Engineering
To study this course, candidates aspiring to gain admission into Software Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subjects.
5. Computer Science (CS)
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
6. Cyber Security
To study this course, candidates aspiring to gain admission into Cyber Security department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subjects.
7. Education and Computer Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Computer Science department.
three (3) other relevant Science subjects.
Nigerian Tertiary Institutions Offering Polymer and Textile Engineering Course