If you are planning to study Pure and Industrial Physics at Bowen University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Bowen University was established in 2001 by the Nigerian Baptist Convention as a private faith-based university focused on academic excellence, discipline, and moral upbringing. This page explains everything you need to know to increase your chances of gaining admission into Bowen University.
Does Bowen University (BU) offer Pure and Industrial Physics?
Is Pure and Industrial Physics listed among Bowen University courses in 2026? If you are looking for the latest Bowen University Faculty of Science courses, it is best to check an updated course list, as Bowen University may change its course offerings. We regularly update our list to reflect the latest available information.
After Confirming Pure and Industrial Physics at Bowen University, Check the Admission Requirements
O’Level Requirements
To study this course, candidates aspiring to gain admission into Pure and Industrial Physics department under Faculty of Science, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one (1) other Science subject from:
Biology or Agricultural Science.
Bowen University Pure and Industrial Physics Suggested Cut-Off Mark if Offered
The general UTME cut-off mark is 180, but due to the variation of Pure and Industrial Physics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bowen University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bowen University Science Courses with their Requirements
1. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
2. Fisheries and Aquaculture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Fisheries and Aquaculture department.
Biology/Agricultural Science,
Physics/Geography/Economics.
3. Information Technology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Information Technology department.
any two (2) other relevant subjects.
4. Forestry and Environmental Management
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Forestry and Environmental Management department.
one of Physics, Economics, Further Mathematics and Statistics.
5. Mechatronics Engineering
To study this course, the minimum requirement for applicants seeking admission to the Mechatronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
6. Pure and Applied Biology
To study this course, candidates aspiring to gain admission into Pure and Applied Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
7. Education and Computer Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Computer Science department.
three (3) other relevant Science subjects.
Nigerian Tertiary Institutions Offering Pure and Industrial Physics Course