If you are planning to study Vocational and Technical Education at Bowen University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Bowen University was established in 2001 by the Nigerian Baptist Convention as a private faith-based university focused on academic excellence, discipline, and moral upbringing. This page explains everything you need to know to increase your chances of gaining admission into Bowen University.
Does Bowen University (BU) offer Vocational and Technical Education?
Is Vocational and Technical Education listed among Bowen University courses in 2026? Because Bowen University's Faculty of Education course offerings may change, we cannot confirm the information as permanent. We recommend checking our updated course list for the latest Bowen University Faculty of Education courses.
After Confirming Vocational and Technical Education at Bowen University, Check the Admission Requirements
O’Level Requirements
To study this course, candidates aspiring to gain admission into Vocational and Technical Education department under Faculty of Education, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject of specialization.
JAMB Subject Combination
any two (2) relevant subjects.
Bowen University Vocational and Technical Education Suggested Cut-Off Mark if Offered
The general UTME cut-off mark is 180, but due to the variation of Vocational and Technical Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bowen University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bowen University Science Courses with their Requirements
1. Surveying and Geoinformatics
To study this course, candidates seeking admission into the Surveying and Geoinformatics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
2. Anatomy
To study this course, the minimum requirement for applicants seeking admission to the Anatomy department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
3. Plant Biology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Plant Biology department.
4. Physiology
To study this course, candidates aspiring to gain admission into Physiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Nursing (Science)
To study this course, candidates seeking admission into the Nursing (Science) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Statistics
To study this course, candidates seeking admission into the Statistics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
7. Forestry and Environmental Management
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Forestry and Environmental Management department.
one of Physics, Economics, Further Mathematics and Statistics.
Nigerian Universities Offering Vocational and Technical Education Course