If you are planning to study Mechanical Engineering at Calvary Polytechnic, Owa-Oyibo located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Calvary Polytechnic.
Does Calvary Polytechnic, Owa-Oyibo offer Mechanical Engineering?
No, Calvary Polytechnic, Owa-Oyibo does not offer Mechanical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Calvary Polytechnic, Owa-Oyibo below to check if the Mechanical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical Engineering When Accredited in Calvary Polytechnic, Owa-Oyibo
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechanical Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
Calvary Polytechnic Cut-Off Mark for Mechanical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Calvary Polytechnic Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Calvary Polytechnic Science Courses with their Requirements
Computer Science (CS)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
Electrical / Electronic Engineering Technology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Electrical / Electronic Engineering Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science Subject.
Computer Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Computer Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Mechanical Engineering Course