If you are planning to study Mechatronics and System Engineering at Chukwuemeka Odumegwu Ojukwu University formally known as Anambra State University (ANSU) located in Anambra State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into COOU.
Does Chukwuemeka Odumegwu Ojukwu University (COOU) offer Mechatronics and System Engineering?
No, Chukwuemeka Odumegwu Ojukwu University does not offer Mechatronics and System Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Chukwuemeka Odumegwu Ojukwu University (COOU) below to check if the Mechatronics and System Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics and System Engineering When Accredited in Chukwuemeka Odumegwu Ojukwu University (COOU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechatronics and System Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
COOU Cut-Off Mark for Mechatronics and System Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics and System Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from COOU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other COOU Science Courses with their Requirements
1. Mechanical Engineering
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
2. Education and Physics
To study this course, candidates seeking admission into the Education and Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects or NTC / NBC.
3. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
4. Electrical / Electronics Engineering
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
5. Education and Computer Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Computer Science department.
three (3) other relevant Science subjects.
6. Biological Science
To study this course, candidates aspiring to gain admission into Biological Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Any other relevant Science subject.
7. Geology
To study this course, the minimum requirement for applicants seeking admission to the Geology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
Nigerian Tertiary Institutions Offering Mechatronics and System Engineering Course