If you are planning to study Electrical and Computer Engineering at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Covenant University was established in 2002 by the Living Faith Church Worldwide as a private Christian university dedicated to raising a new generation of leaders through quality education, research, and innovation. It has since become one of Nigeria’s leading private universities. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Electrical and Computer Engineering?
No, Covenant University, Ota does not offer Electrical and Computer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Electrical and Computer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electrical and Computer Engineering When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical and Computer Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any one other relevant subject.
Covenant University Cut-Off Mark for Electrical and Computer Engineering
The general UTME cut-off mark is 180, but due to the variation of Electrical and Computer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
1. Electrical / Electronics Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
2. Building Technology (BT)
To study this course, candidates seeking admission into the Building Technology (BT) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
3. Industrial Physics With Electronics and IT Application
To study this course, the minimum requirement for applicants seeking admission to the Industrial Physics With Electronics and IT Application department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mathematics and one (1) other Science.
4. Industrial Physics With Applied Geophysics
To study this course, candidates aspiring to gain admission into Industrial Physics With Applied Geophysics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Computer Science (CS)
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
6. Information and Communication Engineering
To study this course, candidates aspiring to gain admission into Information and Communication Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
7. Computer Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Engineering department.
Nigerian Tertiary Institutions Offering Electrical and Computer Engineering Course