If you are planning to study Forestry and Wildlife Technology at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Covenant University was established in 2002 by the Living Faith Church Worldwide as a private Christian university dedicated to raising a new generation of leaders through quality education, research, and innovation. It has since become one of Nigeria’s leading private universities. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Forestry and Wildlife Technology?
No, Covenant University, Ota does not offer Forestry and Wildlife Technology under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Forestry and Wildlife Technology course under the Faculty of Agriculture has been updated.
Admission Requirements for Forestry and Wildlife Technology When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Forestry and Wildlife Technology department under Faculty of Agriculture.
Further Mathematics and Statistics.
JAMB Subject Combination
Biology / Agriculture and
Covenant University Cut-Off Mark for Forestry and Wildlife Technology
The general UTME cut-off mark is 180, but due to the variation of Forestry and Wildlife Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
1. Building Technology (BT)
To study this course, the minimum requirement for applicants seeking admission to the Building Technology (BT) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
2. Petroleum Engineering
To study this course, candidates seeking admission into the Petroleum Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
3. Industrial Physics With Renewable Energy
To study this course, candidates aspiring to gain admission into Industrial Physics With Renewable Energy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
4. Industrial Mathematics
To study this course, candidates seeking admission into the Industrial Mathematics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects.
5. Biochemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
6. Biology
To study this course, candidates seeking admission into the Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics / Physics and
any one other relevant subject.
7. Civil Engineering
To study this course, the minimum requirement for applicants seeking admission to the Civil Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Nigerian Tertiary Institutions Offering Forestry and Wildlife Technology Course