If you are planning to study Genetics and Biotechnology at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Genetics and Biotechnology?
No, Covenant University, Ota does not offer Genetics and Biotechnology under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Genetics and Biotechnology course under the Faculty of Science has been updated.
Admission Requirements for Genetics and Biotechnology When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, candidates seeking admission into the Genetics and Biotechnology department under Faculty of Science, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
JAMB Subject Combination
any other Science subject.
Covenant University Cut-Off Mark for Genetics and Biotechnology
The general UTME cut-off mark is 180, but due to the variation of Genetics and Biotechnology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
Chemical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Chemical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Building Technology (BT)
SSCE Requirements
To study this course, candidates seeking admission into the Building Technology (BT) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Petroleum Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Petroleum Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Electrical / Electronics Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Electrical / Electronics Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Industrial Physics With Renewable Energy
SSCE Requirements
To study this course, candidates aspiring to gain admission into Industrial Physics With Renewable Energy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Mathematics / Physics and
any one other relevant subject.
Mechanical Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Mechanical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
Nigerian Tertiary Institutions Offering Genetics and Biotechnology Course