If you are planning to study Information System at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Covenant University was established in 2002 by the Living Faith Church Worldwide as a private Christian university dedicated to raising a new generation of leaders through quality education, research, and innovation. It has since become one of Nigeria’s leading private universities. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Information System?
No, Covenant University, Ota does not offer Information System under its Faculty of Data and Decision Sciences. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Information System course under the Faculty of Data and Decision Sciences has been updated.
Admission Requirements for Information System When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, candidates seeking admission into the Information System department under Faculty of Data and Decision Sciences, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
three (3) other Science subjects.
JAMB Subject Combination
Chemistry, Physics, Biology, Agric Science, Economics or Geography.
Covenant University Cut-Off Mark for Information System
The general UTME cut-off mark is 180, but due to the variation of Information System cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
1. Industrial Chemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Chemistry department.
Biology / Agricultural Science.
2. Biology
To study this course, candidates aspiring to gain admission into Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Mathematics / Physics and
any one other relevant subject.
3. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
4. Building Technology (BT)
To study this course, the minimum requirement for applicants seeking admission to the Building Technology (BT) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
5. Petroleum Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Petroleum Engineering department.
6. Industrial Physics With Applied Geophysics
To study this course, candidates seeking admission into the Industrial Physics With Applied Geophysics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
7. Chemical Engineering
To study this course, candidates aspiring to gain admission into Chemical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Nigerian Universities Offering Information System Course