If you are planning to study Land Surveying and Geoinformatics at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Covenant University was established in 2002 by the Living Faith Church Worldwide as a private Christian university dedicated to raising a new generation of leaders through quality education, research, and innovation. It has since become one of Nigeria’s leading private universities. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Land Surveying and Geoinformatics?
No, Covenant University, Ota does not offer Land Surveying and Geoinformatics under its Faculty of Built Environment. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Land Surveying and Geoinformatics course under the Faculty of Built Environment has been updated.
Admission Requirements for Land Surveying and Geoinformatics When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, candidates seeking admission into the Land Surveying and Geoinformatics department under Faculty of Built Environment, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics,
Introduction to Building Construction, Bricklaying/Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design,
Wall Hanging, Colour Mixing/Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
Covenant University Cut-Off Mark for Land Surveying and Geoinformatics
The general UTME cut-off mark is 180, but due to the variation of Land Surveying and Geoinformatics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
1. Industrial Mathematics
To study this course, the minimum requirement for applicants seeking admission to the Industrial Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
2. Information and Communication Engineering
To study this course, the minimum requirement for applicants seeking admission to the Information and Communication Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
3. Industrial Physics With Electronics and IT Application
To study this course, candidates aspiring to gain admission into Industrial Physics With Electronics and IT Application department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Mathematics and one (1) other Science.
4. Industrial Physics With Renewable Energy
To study this course, candidates seeking admission into the Industrial Physics With Renewable Energy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Computer Science (CS)
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
6. Building Technology (BT)
To study this course, candidates aspiring to gain admission into Building Technology (BT) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
7. Biochemistry
To study this course, candidates seeking admission into the Biochemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Land Surveying and Geoinformatics Course