If you are planning to study Livestock Production Technology at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Livestock Production Technology?
No, Covenant University, Ota does not offer Livestock Production Technology under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Livestock Production Technology course under the Faculty of Agriculture has been updated.
Admission Requirements for Livestock Production Technology When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, candidates seeking admission into the Livestock Production Technology department under Faculty of Agriculture, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science.
JAMB Subject Combination
Biology / Agricultural Science.
Covenant University Cut-Off Mark for Livestock Production Technology
The general UTME cut-off mark is 180, but due to the variation of Livestock Production Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
1. Microbiology
To study this course, candidates aspiring to gain admission into Microbiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
2. Mechanical Engineering
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
3. Industrial Physics With Applied Geophysics
To study this course, the minimum requirement for applicants seeking admission to the Industrial Physics With Applied Geophysics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
4. Petroleum Engineering
To study this course, candidates aspiring to gain admission into Petroleum Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Industrial Physics With Renewable Energy
To study this course, candidates seeking admission into the Industrial Physics With Renewable Energy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Industrial Physics With Electronics and IT Application
To study this course, candidates seeking admission into the Industrial Physics With Electronics and IT Application department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics and one (1) other Science.
7. Building Technology (BT)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building Technology (BT) department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Nigerian Tertiary Institutions Offering Livestock Production Technology Course