If you are planning to study Systems Engineering at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Systems Engineering?
No, Covenant University, Ota does not offer Systems Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Systems Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Systems Engineering When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Systems Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Covenant University Cut-Off Mark for Systems Engineering
The general UTME cut-off mark is 180, but due to the variation of Systems Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
1. Petroleum Engineering
To study this course, candidates seeking admission into the Petroleum Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Industrial Mathematics
To study this course, the minimum requirement for applicants seeking admission to the Industrial Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
3. Industrial Physics With Renewable Energy
To study this course, the minimum requirement for applicants seeking admission to the Industrial Physics With Renewable Energy department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
4. Industrial Physics With Applied Geophysics
To study this course, candidates seeking admission into the Industrial Physics With Applied Geophysics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Electrical / Electronics Engineering
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
6. Biology
To study this course, the minimum requirement for applicants seeking admission to the Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mathematics / Physics and
any one other relevant subject.
7. Architecture
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Systems Engineering Course