If you are planning to study Vocational and Technical Education at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Vocational and Technical Education?
No, Covenant University, Ota does not offer Vocational and Technical Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Vocational and Technical Education course under the Faculty of Education has been updated.
Admission Requirements for Vocational and Technical Education When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Vocational and Technical Education department under Faculty of Education.
any other relevant subject of specialization.
JAMB Subject Combination
any two (2) relevant subjects.
Covenant University Cut-Off Mark for Vocational and Technical Education
The general UTME cut-off mark is 180, but due to the variation of Vocational and Technical Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
Chemical Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Chemical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Computer Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Engineering department.
Industrial Physics With Electronics and IT Application
SSCE Requirements
To study this course, candidates seeking admission into the Industrial Physics With Electronics and IT Application department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics and one (1) other Science.
Building Technology (BT)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building Technology (BT) department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Information and Communication Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Information and Communication Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
Industrial Chemistry
SSCE Requirements
To study this course, candidates seeking admission into the Industrial Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science.
Industrial Mathematics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Industrial Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
Nigerian Universities Offering Vocational and Technical Education Course