If you are planning to study Orthopaedic and Plaster Technology at Cross River State Institute of Technology And Management located in Cross River State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Cross River State Institute.
Does Cross River State Institute of Technology And Management offer Orthopaedic and Plaster Technology?
No, Cross River State Institute of Technology And Management does not offer Orthopaedic and Plaster Technology under its Faculty of Allied Health Sciences. However, since our course list is updated regularly, you can visit the courses available at Cross River State Institute of Technology And Management below to check if the Orthopaedic and Plaster Technology course under the Faculty of Allied Health Sciences has been updated.
Admission Requirements for Orthopaedic and Plaster Technology When Accredited in Cross River State Institute of Technology And Management
O’Level Requirements
To study this course, candidates seeking admission into the Orthopaedic and Plaster Technology department under Faculty of Allied Health Sciences, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Cross River State Institute Cut-Off Mark for Orthopaedic and Plaster Technology
The general UTME cut-off mark is 230, but due to the variation of Orthopaedic and Plaster Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Cross River State Institute Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Cross River State Institute Science Courses with their Requirements
Education and Physics
SSCE Requirements
To study this course, candidates seeking admission into the Education and Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects or NTC / NBC.
Wood Production Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Wood Production Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Technical Education
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Technical Education department.
any three (3) relevant subjects.
Biochemistry
SSCE Requirements
To study this course, candidates seeking admission into the Biochemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Plant Science and Biotechnology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Plant Science and Biotechnology department.
Agriculture
SSCE Requirements
To study this course, candidates seeking admission into the Agriculture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science,
Mathematics / Physics, and
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Orthopaedic and Plaster Technology Course