If you are planning to study Chemical and Polymer Engineering at University of Cross River State formally known as Cross Rivers University of Technology (CRUTECH) located in Cross River State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNICROSS was established in 2021 by the Cross River State Government as a merger and upgrade of former tertiary institutions. It was created to strengthen higher education and innovation in the state. This page explains everything you need to know to increase your chances of gaining admission into UNICROSS.
Does University of Cross River State (UNICROSS) offer Chemical and Polymer Engineering?
No, University of Cross River State does not offer Chemical and Polymer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Cross River State (UNICROSS) below to check if the Chemical and Polymer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Chemical and Polymer Engineering When Accredited in University of Cross River State (UNICROSS)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Chemical and Polymer Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
UNICROSS Cut-Off Mark for Chemical and Polymer Engineering
The general UTME cut-off mark is 180, but due to the variation of Chemical and Polymer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNICROSS Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNICROSS Science Courses with their Requirements
1. Agriculture
To study this course, candidates aspiring to gain admission into Agriculture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science,
Mathematics / Physics, and
2. Mathematics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mathematics department.
any two (2) other relevant subjects.
3. Statistics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Statistics department.
any other relevant subject.
4. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
5. Electrical / Electronics Engineering
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
6. Physics
To study this course, the minimum requirement for applicants seeking admission to the Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
7. Wood Production Engineering
To study this course, candidates aspiring to gain admission into Wood Production Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Nigerian Tertiary Institutions Offering Chemical and Polymer Engineering Course