If you are planning to study Metallurgical and Material Engineering at University of Cross River State formally known as Cross Rivers University of Technology (CRUTECH) located in Cross River State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNICROSS was established in 2021 by the Cross River State Government as a merger and upgrade of former tertiary institutions. It was created to strengthen higher education and innovation in the state. This page explains everything you need to know to increase your chances of gaining admission into UNICROSS.
Does University of Cross River State (UNICROSS) offer Metallurgical and Material Engineering?
No, University of Cross River State does not offer Metallurgical and Material Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Cross River State (UNICROSS) below to check if the Metallurgical and Material Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical and Material Engineering When Accredited in University of Cross River State (UNICROSS)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Metallurgical and Material Engineering department under Faculty of Engineering / Technology.
one other Science subject.
UNICROSS Cut-Off Mark for Metallurgical and Material Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical and Material Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNICROSS Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNICROSS Science Courses with their Requirements
1. Forestry and Wildlife
To study this course, candidates seeking admission into the Forestry and Wildlife department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Further Mathematics and Statistics.
2. Education and Biology
To study this course, the minimum requirement for applicants seeking admission to the Education and Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
3. Biology
To study this course, the minimum requirement for applicants seeking admission to the Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mathematics / Physics and
any one other relevant subject.
4. Statistics
To study this course, candidates aspiring to gain admission into Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
5. Architecture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
6. Biological Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biological Science department.
Any other relevant Science subject.
7. Hospitality and Tourism Management
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Hospitality and Tourism Management department.
any two (2) other relevant subjects.
Nigerian Universities Offering Metallurgical and Material Engineering Course