If you are planning to study Production Engineering at University of Cross River State formally known as Cross Rivers University of Technology (CRUTECH) located in Cross River State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNICROSS was established in 2021 by the Cross River State Government as a merger and upgrade of former tertiary institutions. It was created to strengthen higher education and innovation in the state. This page explains everything you need to know to increase your chances of gaining admission into UNICROSS.
Does University of Cross River State (UNICROSS) offer Production Engineering?
No, University of Cross River State does not offer Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Cross River State (UNICROSS) below to check if the Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Production Engineering When Accredited in University of Cross River State (UNICROSS)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Production Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
UNICROSS Cut-Off Mark for Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNICROSS Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNICROSS Science Courses with their Requirements
1. Agriculture
To study this course, candidates seeking admission into the Agriculture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science,
Mathematics / Physics, and
2. Plant Science and Biotechnology
To study this course, candidates aspiring to gain admission into Plant Science and Biotechnology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Computer Science (CS)
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
4. Hospitality and Tourism Management
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Hospitality and Tourism Management department.
any two (2) other relevant subjects.
5. Agricultural Science and Education
To study this course, candidates seeking admission into the Agricultural Science and Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology/Agricultural Science,
any other relevant subject.
6. Architecture
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
7. Technical Education
To study this course, candidates seeking admission into the Technical Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any three (3) relevant subjects.
Nigerian Tertiary Institutions Offering Production Engineering Course