If you are planning to study Pure and Industrial Physics at University of Cross River State formally known as Cross Rivers University of Technology (CRUTECH) located in Cross River State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNICROSS was established in 2021 by the Cross River State Government as a merger and upgrade of former tertiary institutions. It was created to strengthen higher education and innovation in the state. This page explains everything you need to know to increase your chances of gaining admission into UNICROSS.
Does University of Cross River State (UNICROSS) offer Pure and Industrial Physics?
No, University of Cross River State does not offer Pure and Industrial Physics under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at University of Cross River State (UNICROSS) below to check if the Pure and Industrial Physics course under the Faculty of Science has been updated.
Admission Requirements for Pure and Industrial Physics When Accredited in University of Cross River State (UNICROSS)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Pure and Industrial Physics department under Faculty of Science, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one (1) other Science subject from:
Biology or Agricultural Science.
UNICROSS Cut-Off Mark for Pure and Industrial Physics
The general UTME cut-off mark is 180, but due to the variation of Pure and Industrial Physics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNICROSS Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNICROSS Science Courses with their Requirements
1. Wood Production Engineering
To study this course, candidates seeking admission into the Wood Production Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
2. Architecture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
3. Biochemistry
To study this course, candidates seeking admission into the Biochemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
4. Computer Science (CS)
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
5. Human Kinetics and Health Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Human Kinetics and Health Education department.
any three (3) other relevant subjects.
6. Electrical / Electronics Engineering
To study this course, candidates seeking admission into the Electrical / Electronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
7. Technical Education
To study this course, the minimum requirement for applicants seeking admission to the Technical Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any three (3) relevant subjects.
Nigerian Tertiary Institutions Offering Pure and Industrial Physics Course