If you are planning to study Electrical and Electronics Engineering (EEE) at Delta State University of Science and Technology located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into DSUST.
Does Delta State University of Science and Technology (DSUST) offer Electrical and Electronics Engineering?
No, Delta State University of Science and Technology does not offer Electrical and Electronics Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Delta State University of Science and Technology (DSUST) below to check if the Electrical and Electronics Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electrical and Electronics Engineering (EEE) When Accredited in Delta State University of Science and Technology (DSUST)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical and Electronics Engineering (EEE) department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
DSUST Cut-Off Mark for Electrical and Electronics Engineering (EEE)
The general UTME cut-off mark is 180, but due to the variation of Electrical and Electronics Engineering (EEE) cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from DSUST Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other DSUST Science Courses with their Requirements
1. Chemical Engineering
To study this course, candidates aspiring to gain admission into Chemical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
2. Petroleum Chemistry
To study this course, candidates aspiring to gain admission into Petroleum Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Mechanical Engineering
To study this course, candidates aspiring to gain admission into Mechanical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
4. Environmental Management and Toxicology
To study this course, the minimum requirement for applicants seeking admission to the Environmental Management and Toxicology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
5. Quantity Surveying (QS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Quantity Surveying (QS) department.
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
6. Petroleum Engineering
To study this course, the minimum requirement for applicants seeking admission to the Petroleum Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
7. Food Science and Technology (FT)
To study this course, candidates aspiring to gain admission into Food Science and Technology (FT) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subject from;
Biology / Agricultural Science, Physics, Basic Catering and Food Services, Bakery and Confectionaries,
Nigerian Universities Offering Electrical and Electronics Engineering Course