If you are planning to study Remote Sensing and Geosciences Information System at Delta State University of Science and Technology located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. DSUST was established in 2021 by the Delta State Government to advance science, technology, engineering, and innovation-driven education. The university was created to support technological development and economic transformation. This page explains everything you need to know to increase your chances of gaining admission into DSUST.
Does Delta State University of Science and Technology (DSUST) offer Remote Sensing and Geosciences Information System?
No, Delta State University of Science and Technology does not offer Remote Sensing and Geosciences Information System under its Faculty of Earth and Mineral Sciences. However, since our course list is updated regularly, you can visit the courses available at Delta State University of Science and Technology (DSUST) below to check if the Remote Sensing and Geosciences Information System course under the Faculty of Earth and Mineral Sciences has been updated.
Admission Requirements for Remote Sensing and Geosciences Information System When Accredited in Delta State University of Science and Technology (DSUST)
O’Level Requirements
To study this course, candidates seeking admission into the Remote Sensing and Geosciences Information System department under Faculty of Earth and Mineral Sciences, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Joinery,
Floors and Ceiling Finishing, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
JAMB Subject Combination
Art, Biology and Economics.
DSUST Cut-Off Mark for Remote Sensing and Geosciences Information System
The general UTME cut-off mark is 180, but due to the variation of Remote Sensing and Geosciences Information System cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from DSUST Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other DSUST Science Courses with their Requirements
1. Mechanical Engineering
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
2. Chemical Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Chemical Engineering department.
any other Science subject.
3. Chemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Chemistry department.
4. Petroleum Chemistry
To study this course, candidates aspiring to gain admission into Petroleum Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
5. Physics
To study this course, the minimum requirement for applicants seeking admission to the Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
6. Agricultural Engineering (AE)
To study this course, candidates aspiring to gain admission into Agricultural Engineering (AE) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Any one other subject from:
Introduction to Agricultural Science,
Materials and Workshop Process and Machining,
Tractor Layout Power Unit Under Carriage and Auto Electricity;
Transmission System;
Implement and Machine;
Principles of Crop Husbandry and Land Use,
Materials and Workshop Processes;
Construction and Maintenance of Agricultural Machines;
General Metal Work;
General Wood Work and Building / Engineering Drawing.
7. Petroleum Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Petroleum Engineering department.
Nigerian Tertiary Institutions Offering Remote Sensing and Geosciences Information System Course