If you are planning to study Vocational and Technical Education at Delta State University of Science and Technology located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. DSUST was established in 2021 by the Delta State Government to advance science, technology, engineering, and innovation-driven education. The university was created to support technological development and economic transformation. This page explains everything you need to know to increase your chances of gaining admission into DSUST.
Does Delta State University of Science and Technology (DSUST) offer Vocational and Technical Education?
No, Delta State University of Science and Technology does not offer Vocational and Technical Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Delta State University of Science and Technology (DSUST) below to check if the Vocational and Technical Education course under the Faculty of Education has been updated.
Admission Requirements for Vocational and Technical Education When Accredited in Delta State University of Science and Technology (DSUST)
O’Level Requirements
To study this course, candidates seeking admission into the Vocational and Technical Education department under Faculty of Education, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject of specialization.
JAMB Subject Combination
any two (2) relevant subjects.
DSUST Cut-Off Mark for Vocational and Technical Education
The general UTME cut-off mark is 180, but due to the variation of Vocational and Technical Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from DSUST Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other DSUST Science Courses with their Requirements
1. Soil Science
To study this course, candidates seeking admission into the Soil Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science and
any other Science subject.
2. Petroleum Engineering
To study this course, the minimum requirement for applicants seeking admission to the Petroleum Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
3. Cyber Security
To study this course, candidates seeking admission into the Cyber Security department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects.
4. Petroleum Chemistry
To study this course, candidates seeking admission into the Petroleum Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Software Engineering
To study this course, candidates seeking admission into the Software Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects.
6. Urban and Regional Planning (URP)
To study this course, candidates seeking admission into the Urban and Regional Planning (URP) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Physics, Chemistry, Economics, Government, Biology, Art, History, IRK/CRK, Social Studies and Tech Drawing.
7. Quantity Surveying (QS)
To study this course, candidates aspiring to gain admission into Quantity Surveying (QS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any of Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
Nigerian Universities Offering Vocational and Technical Education Course