If you are planning to study Building and Woodwork Technology Education at Eastern Palm University, Ogboko located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into EPU.
Does Eastern Palm University, Ogboko (EPU) offer Building and Woodwork Technology Education?
No, Eastern Palm University, Ogboko does not offer Building and Woodwork Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Eastern Palm University, Ogboko (EPU) below to check if the Building and Woodwork Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Building and Woodwork Technology Education When Accredited in Eastern Palm University, Ogboko (EPU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Building and Woodwork Technology Education department under Faculty of Education, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
EPU Cut-Off Mark for Building and Woodwork Technology Education
The general UTME cut-off mark is 180, but due to the variation of Building and Woodwork Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EPU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EPU Science Courses with their Requirements
1. Animal and Environmental Biology
To study this course, candidates aspiring to gain admission into Animal and Environmental Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subject.
2. Architecture
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
3. Biology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biology department.
Mathematics / Physics and
any one other relevant subject.
4. Education and Physics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Physics department.
two (2) other Science subjects or NTC / NBC.
5. Microbiology
To study this course, candidates seeking admission into the Microbiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Statistics
To study this course, candidates seeking admission into the Statistics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
7. Plant Science and Biotechnology
To study this course, candidates seeking admission into the Plant Science and Biotechnology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Building and Woodwork Technology Education Course