If you are planning to study Dental Technology at Eastern Palm University, Ogboko located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into EPU.
Does Eastern Palm University, Ogboko (EPU) offer Dental Technology?
No, Eastern Palm University, Ogboko does not offer Dental Technology under its Faculty of Health and Medical Sciences. However, since our course list is updated regularly, you can visit the courses available at Eastern Palm University, Ogboko (EPU) below to check if the Dental Technology course under the Faculty of Health and Medical Sciences has been updated.
Admission Requirements for Dental Technology When Accredited in Eastern Palm University, Ogboko (EPU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Dental Technology department under Faculty of Health and Medical Sciences, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
JAMB Subject Combination
one (1) other Science subject.
EPU Cut-Off Mark for Dental Technology
The general UTME cut-off mark is 230, but due to the variation of Dental Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EPU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EPU Science Courses with their Requirements
Education and Physics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects or NTC / NBC.
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Biology
SSCE Requirements
To study this course, candidates seeking admission into the Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics / Physics and
any one other relevant subject.
Physics Electronics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Physics Electronics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Chemistry, Mathematics and
any other Science subject from
Further Mathematics and Biology or Agricultural Science.
Biochemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
Mathematics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mathematics department.
any two (2) other relevant subjects.
Education and Chemistry
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology and Agricultural Science.
Nigerian Tertiary Institutions Offering Dental Technology Course