If you are planning to study Electrical and Information Engineering at Eastern Palm University, Ogboko located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into EPU.
Does Eastern Palm University, Ogboko (EPU) offer Electrical and Information Engineering?
No, Eastern Palm University, Ogboko does not offer Electrical and Information Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Eastern Palm University, Ogboko (EPU) below to check if the Electrical and Information Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electrical and Information Engineering When Accredited in Eastern Palm University, Ogboko (EPU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Electrical and Information Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant science subject.
JAMB Subject Combination
any other science subject.
EPU Cut-Off Mark for Electrical and Information Engineering
The general UTME cut-off mark is 180, but due to the variation of Electrical and Information Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EPU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EPU Science Courses with their Requirements
Computer Science (CS)
SSCE Requirements
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
Education and Biology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Biology department.
Education and Chemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Chemistry department.
Biology and Agricultural Science.
Education and Computer Science
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Computer Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
three (3) other relevant Science subjects.
Animal and Environmental Biology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Animal and Environmental Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subject.
Physics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Physics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Electrical and Information Engineering Course