If you are planning to study Engineering Physics at Eastern Palm University, Ogboko located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. EPU was established in 2016 by the Imo State Government as a state-owned university located in Ogboko. The institution was created to expand access to higher education and promote research, innovation, and community development. This page explains everything you need to know to increase your chances of gaining admission into EPU.
Does Eastern Palm University, Ogboko (EPU) offer Engineering Physics?
No, Eastern Palm University, Ogboko does not offer Engineering Physics under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Eastern Palm University, Ogboko (EPU) below to check if the Engineering Physics course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Engineering Physics When Accredited in Eastern Palm University, Ogboko (EPU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Engineering Physics department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any one (1) of Health Science, Statistics, Physics and Geography.
JAMB Subject Combination
either Physics or Mathematics.
EPU Cut-Off Mark for Engineering Physics
The general UTME cut-off mark is 180, but due to the variation of Engineering Physics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EPU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EPU Science Courses with their Requirements
1. Architecture
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
2. Microbiology
To study this course, the minimum requirement for applicants seeking admission to the Microbiology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
3. Physics Electronics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physics Electronics department.
Chemistry, Mathematics and
any other Science subject from
Further Mathematics and Biology or Agricultural Science.
4. Education and Chemistry
To study this course, the minimum requirement for applicants seeking admission to the Education and Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology and Agricultural Science.
5. Plant Science and Biotechnology
To study this course, the minimum requirement for applicants seeking admission to the Plant Science and Biotechnology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
6. Biochemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
7. Computer Science (CS)
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
Nigerian Tertiary Institutions Offering Engineering Physics Course