If you are planning to study Prosthesis and Orthopaedic Technology at Ebonyi State University located in Ebonyi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. EBSU was established in 1999 by the Ebonyi State Government to provide quality higher education and promote research, innovation, and human capital development within the state and beyond. This page explains everything you need to know to increase your chances of gaining admission into EBSU.
Does Ebonyi State University (EBSU) offer Prosthesis and Orthopaedic Technology?
No, Ebonyi State University does not offer Prosthesis and Orthopaedic Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ebonyi State University (EBSU) below to check if the Prosthesis and Orthopaedic Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Prosthesis and Orthopaedic Technology When Accredited in Ebonyi State University (EBSU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Prosthesis and Orthopaedic Technology department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
EBSU Cut-Off Mark for Prosthesis and Orthopaedic Technology
The general UTME cut-off mark is 180, but due to the variation of Prosthesis and Orthopaedic Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EBSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EBSU Science Courses with their Requirements
1. Education and Computer Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Computer Science department.
three (3) other relevant Science subjects.
2. Education and Biology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Biology department.
3. Industrial Mathematics / Applied Statistics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Mathematics / Applied Statistics department.
two (2) other Science subjects.
4. Computer Science (CS)
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
5. Industrial Chemistry
To study this course, the minimum requirement for applicants seeking admission to the Industrial Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science.
6. Physiology
To study this course, the minimum requirement for applicants seeking admission to the Physiology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
7. Electrical / Electronics Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
Nigerian Tertiary Institutions Offering Prosthesis and Orthopaedic Technology Course