If you are planning to study Mechatronics Engineering at Ekiti State University located in Ekiti State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. EKSU was established in 1982 as Obafemi Awolowo University, Ado-Ekiti, and became a full-fledged state university in 1985. It was later renamed Ekiti State University and has grown into one of Nigeria’s leading state-owned universities. This page explains everything you need to know to increase your chances of gaining admission into EKSU.
Does Ekiti State University (EKSU) offer Mechatronics Engineering?
No, Ekiti State University does not offer Mechatronics Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ekiti State University (EKSU) below to check if the Mechatronics Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics Engineering When Accredited in Ekiti State University (EKSU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechatronics Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
EKSU Cut-Off Mark for Mechatronics Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EKSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Nigerian Universities Offering Mechatronics Engineering Course