If you are planning to study Agricultural Extension and Rural Development at Enugu State University of Science & Technology located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. ESUT was established in 1980 as Anambra State University of Technology before becoming Enugu State University of Science and Technology in 1991 following the creation of Enugu State. It is recognized as one of Nigeria’s pioneering universities of technology. This page explains everything you need to know to increase your chances of gaining admission into ESUT.
Does Enugu State University of Science & Technology (ESUT) offer Agricultural Extension and Rural Development?
No, Enugu State University of Science & Technology does not offer Agricultural Extension and Rural Development under its Faculty of Renewable and Natural Resources. However, since our course list is updated regularly, you can visit the courses available at Enugu State University of Science & Technology (ESUT) below to check if the Agricultural Extension and Rural Development course under the Faculty of Renewable and Natural Resources has been updated.
Admission Requirements for Agricultural Extension and Rural Development When Accredited in Enugu State University of Science & Technology (ESUT)
O’Level Requirements
To study this course, candidates seeking admission into the Agricultural Extension and Rural Development department under Faculty of Renewable and Natural Resources, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Chemistry, Biology / Agricultural Science
Geography, Physics and Economics.
ESUT Cut-Off Mark for Agricultural Extension and Rural Development
The general UTME cut-off mark is 180, but due to the variation of Agricultural Extension and Rural Development cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ESUT Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ESUT Science Courses with their Requirements
1. Surveying and Geoinformatics
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Surveying and Geoinformatics department.
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
2. Physical and Health Education
To study this course, candidates aspiring to gain admission into Physical and Health Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology or its equivalent
and any two (2) other relevant subjects.
3. Electrical / Electronics Engineering
To study this course, candidates aspiring to gain admission into Electrical / Electronics Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
4. Pharmacy
To study this course, candidates seeking admission into the Pharmacy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Geography and Meteorology
To study this course, candidates aspiring to gain admission into Geography and Meteorology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Arts or Social Science subjects with at least a pass in Mathematics.
6. Biology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biology department.
Mathematics / Physics and
any one other relevant subject.
7. Metallurgical and Material Engineering
To study this course, the minimum requirement for applicants seeking admission to the Metallurgical and Material Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one other Science subject.
Nigerian Universities Offering Agricultural Extension and Rural Development Course